The GPU still does not register fan-speed, so I fear that the fan-controller is broken. I have since replaced the fans, and I know for a fact they are working correctly because I’ve tested them separate from the GPU, even the tachometer signal is working fine. Obviously, this meant that the GPU would not register fan-speed, so the fan-controller would ramp up the speed of the other fan to 100% even though the GPU was almost room-temperature (40C/100F) and no load. One of the two fans did not spin, and it was the fan that has the tachometer signal cable coming out of it. Rule 2// The screw holes between the two fans must be 15mm width on the radiator for either 120mm or 140mm UNI FAN.I bought a GTX 1070 a while back, but never put it to use because it had a broken fan. Rule 1// The tubes of the radiator must avoid the tenon of the UNI FAN and be at the safe area, which is in grey in the image. Radiators that doesn’t follow bellow rule:.CORSAIR Hydro Series™ H110i GT 280mm Extreme Performance Liquid CPU Cooler.CORSAIR iCUE H115i RGB PRO XT Liquid CPU Cooler.Listed radiators are known not compatible with UNI FAN.
To connect more devices, please update to L-Connect 2 (reference to update guide) and use 2 or more controllers. Do not connect more than 10 UNI FANs (device up to 21W) to the controller (UNI HUB) when performing white static color.(Update your motherboard BIOS if necessary) Please enter your motherboard BIOS and set the correspondent fan header at PWM mode.Please note that the single-pack version does not contain this controller. To control all 16 UNI FANs (4 fans each cluster) in one go, a controller is needed, no matter control with L-Connect software or sync to the motherboard. Purchase a three-pack SL120 or a two-pack SL140(including a controller) as the starter kit for fully experienced UNI FANs with L-Connect.
0 kommentar(er)
